| Injection Trial Report | ||||||||||
| Date: Hour: 1 | ||||||||||
| Product Name: Part Name: 1 | ||||||||||
| Mold No.: Trial No.: 1 | ||||||||||
| Factory: Mold Maker: 1 | ||||||||||
| Participants: 1. 2. 3. 1 | ||||||||||
| Machine: Clamping Force: Part Weight: 1 | ||||||||||
| Machine Date: | ||||||||||
| NO. Of Side Cores: Clamping Force During Injection: 1 | ||||||||||
| Cylinder Temperature By Zone: | ||||||||||
| 220 | 240 | 240 | 240 | 230 | ||||||
| Hot Runners Temperature: | ||||||||||
| Manifold | ||||||||||
| Nozzles | ||||||||||
| Injection Parameters: | ||||||||||
| Injection Profile | ||||||||||
| Speed in: % or mm/sec | ||||||||||
| Pressure(bar) | ||||||||||
| Injection Time: (sec) Cooling Time: (sec) | ||||||||||
| Follow Up Pressure: | ||||||||||
| Bar | ||||||||||
| Duration | ||||||||||
| Cycle Time: 1 | ||||||||||
| Machine Status | ||||||||||
| Automatic | Semiautomatic | |||||||||
| Mold Temp/Air Parameters: | ||||||||||
| Side Core | Cavity Side | Core Side | Factory | |||||||
| Temperature | ||||||||||
| Air Ejection | ||||||||||
| Raw Material | ||||||||||
| Mat. Name | PP Coop | PP Random | ||||||||
| % | 100% | 100% | ||||||||
| FI | 30 | 30 | ||||||||
| Remarks: | ||||||||||
| 1. Check Injection Point Diameter D=1.6-1.8mm. | ||||||||||
| 2．If You Still Have Filling Problem Tray PP Material With Higher FI～40-45 | ||||||||||
| 欢迎光临 iCAx开思网 (https://www.icax.org/) | Powered by Discuz! X3.3 |