iCAx开思网

标题: 急急！！！大虾们过来看看吧！ [打印本页]

作者: 稀饭 时间: 2002-11-30 12:42
标题: 急急！！！大虾们过来看看吧！
::6大虾们过来看看下面的内容吧！
具体参数是什么意思？怎么设置？小弟在此先谢了！
-------------------------------------------------------------------------------------------------------
This file may be edited using available editor.Just type on the necessary lines appropriate values after the"="sign.Comments are not permitted on lines containing material properties names.
YOUNG-MODULUS=
POISSON- RATIO=
SHEAR-MODULUS=
MASS-DENSITY=
THERMAL-EXPANSION-COEFFICIENT=
THERMAL-EXPANSION-REF-TEMPERATURE=
STRUCTURAL-DAMLING-COEFFICIENT=
STRESS-LIMIT-FOR-TENSION=
STRESS-LIMIT-FOR-COMPRESSION=
STRESS-LIMIT-FOR-SHEAR=
THERMAL-CONCLUCTIVITY=
EMISSIUITY=
SPECIFIC-HEAT=
HARDNESS=
CONDITION=
INITIAL-BEND-Y-FACTOR=
BEND-TABLE=
PRO-UNIT-MASS=
PRO-UNIT-LENGTH=
PRO-UNIT-SYS=

作者: zzabccn 时间: 2002-12-2 04:33
proe自带有铝、铜、钢、钛的设置.可能单位是英制的.可在proe安装文件夹中查找*.mat文件.?:\proe2001\jlink\jlink_appls\jlink_elev
这里只说一说我知道的:
STRESS-LIMIT-FOR-TENSION= 抗拉强度
STRESS-LIMIT-FOR-COMPRESSION= 抗压强度
STRESS-LIMIT-FOR-SHEAR= 抗剪强度
HARDNESS= 硬度
BEND-TABLE= 折弯表,用于扳金折弯或扭曲中的几个折弯的中性层位置控制.
这些参数可用于定义关系尺寸,例如压力容器的壁厚.

        MATERIAL  ST1020

This file may be edited using available editor.
Just type on the necessary lines appropriate values
after the "=" sign. Comments are not permitted on
lines containing material properties names.

YOUNG_MODULUS                   =    30E6
POISSON_RATIO                   =    0.29
SHEAR_MODULUS                   =    12E6
MASS_DENSITY                   =    489.84
THERMAL_EXPANSION_COEFFICIENT =    8.4E-6
THERM_EXPANSION_REF_TEMPERATURE  =    60
STRUCTURAL_DAMPING_COEFFICIENT =    0.22
STRESS_LIMIT_FOR_TENSION       =    65E3
STRESS_LIMIT_FOR_COMPRESSION    =    65E3
STRESS_LIMIT_FOR_SHEAR          =    19E3
THERMAL_CONDUCTIVITY          =    27
EMISSIVITY                      =    0.45
SPECIFIC_HEAT                   =    0.10
HARDNESS                      =    150
CONDITION                      =    N/A
INITIAL_BEND_Y_FACTOR          =    0.2
BEND_TABLE                      =    tableSt1020
PRO_UNIT_MASS                   =
PRO_UNIT_LENGTH                =
PRO_UNIT_SYS                   =

作者: 稀饭 时间: 2002-12-8 11:43
谢了！！楼上的兄弟

欢迎光临 iCAx开思网 (https://www.icax.org/)