iCAx开思网

标题: PROE中的精度问题 [打印本页]

作者: cliffdon    时间: 2004-12-8 11:46
标题: PROE中的精度问题
在学模具设计的过程中遇到这个问题:
因为有细节出差不能生从MOLD VOLUM中生成PART,故改小了相对精度后能生成PART ,但不能生成MOLDING。系统提示精度有问题,以下是文件,请问大师怎么解决?
ccuracy Conflict Report For Assembly MFG0001.
  
1. Models in the list may have accuracy set to absolute or relative accuracy.
2. When the model's accuracy is relative, an absolute accuracy value  
is calculated based on the model's relative accuracy.
3. The following list shows the absolute accuracy value for each model  
that is actually used in geometry calculations.
  
       Generic Model Name           Abs Accuracy Value  Unit Name
MFG0001.ASM                           0.015339900       mm
MFG0001_REF.PRT                       0.005000000       mm
MFG0001_WRK.PRT                       0.013731906       mm
CAVITY-INSERT.PRT                     0.030679800       mm
CAVITY-INSERT-1.PRT                   0.030679800       mm
CAVITY-INLAY-1.PRT                    0.030679800       mm
CAVITY-INLAY-2.PRT                    0.030679800       mm
CORE-INSERT.PRT                       0.030679800       mm
CAVITY-INLAY-3.PRT                    0.030679800       mm
CAVITY.PRT                            0.030679800       mm
LIFT-M1.PRT                           0.030679800       mm
LIFTER-M2.PRT                         0.030679800       mm
CORE.PRT                              0.015317670       mm
作者: luyunq    时间: 2004-12-8 12:08
导到topsolid里面去试试看。可能有意外的收获。
作者: aqqaqq    时间: 2004-12-9 12:46
可修改绝对精度,使之一致。




欢迎光临 iCAx开思网 (https://www.icax.org/) Powered by Discuz! X3.3