| 序號 | 工序\工藝中文 | 工序\工藝英文 | |
| 1 | 沖孔\下料 | 復合 | Compound |
| 2 | 下料 | 僅下外形 | Blank\Blanking |
| 3 | 沖孔 | 沖孔 | Pierce |
| 4 | 側沖 | Cam Pierce | |
| 5 | 預沖 | Pre-Pierce | |
| 6 | 打沙拉 | C'sink | |
| 7 | 打沉頭 | Coun-Bore | |
| 8 | 抽牙\抽孔 | Extrude\Extrusion | |
| 9 | 折彎 | 一般折 | Bend |
| 10 | U-折 | U-Bend | |
| 11 | V-折 | V-Bend | |
| 12 | Z-折 | Z-Bend | |
| 13 | 折不規則邊 | Form | |
| 14 | 打圓凸包 | Emboss | |
| 15 | 打不規則凸包 | Forming | |
| 16 | 打補強 | 長條形 | Rib Form |
| 17 | 三角形 | Gusset\Knifing | |
| 18 | 壓毛邊 | Coin | |
| 19 | 反折壓平 | Hem | |
| 20 | 空步 | Idle | |
| 21 | 捲圓 | Curling | |
| 22 | 鉚合 | 抽牙沙拉 | Flaring |
| 23 | 無孔鉚合(三點) | Toxing | |
| 24 | 無孔鉚合(三線) | Tog-L-Lock | |
| 25 | 拉釘鉚合 | Riveting | |
| 26 | 鉚螺柱 | Staking | |
| 27 | 點焊 | 不打點 | Welding\Spot Welding |
| 28 | 打點 | Projection Welding | |
| 29 | 整形 | Shaping\Re-strike | |
| 30 | 切破 | Lancing | |
| 31 | 半切破 | Half Cut | |
| 32 | 切邊 | 一般切 | Trim |
| 33 | 側切 | Cam Trim\Side Trim | |
| 34 | 打天橋 | Bridge Form\Bridge Lance | |
| 35 | 拉伸 | Drawing | |
| 36 | 擠薄 | Thinning | |
| 37 | 壓厚 | Back Pack | |
| 38 | 打字模 | Lettering | |
| 39 | 打壓印 | Marking | |
| 40 | 打百葉窗 | Louver | |
| 41 | 旋壓 | Spinning | |
| 42 | 沖引導孔 | Pilot | |
| 43 | 切節距 | Notch\French Notch | |
| 欢迎光临 iCAx开思网 (https://www.icax.org/) | Powered by Discuz! X3.3 |