=============================================
I created a sedan carpet (floor cover) styling surface in CATIA GSD workbench, then I finish it after some additive operation, such as thick surface, split, edge fillet...
It is very strange that the styling surface was convicted of having some illegal gaps over 0.02mm. I am sure every gap must be smaller than 0.001mm when I processing the styling surface. where these illegal gaps come from?
Dear guys, show your experince please, I am confused for the trouble. I believe that most of reverse engineering guys maybe not strange with it. Could you please tell me how to deat with it and how to avoid it in my future task? Thanks a million.作者: 3400129 时间: 2006-6-8 17:18
把公差调小！应该能检查到在什么位置的！通过合并以后的面在公差范围内有一些移动从而合并到一个面上的！像你这样的应该达到A面了吧！作者: imageware 时间: 2006-6-8 18:40
1.找你作地板的哥们要他作地板的基础面，就很方便了；没有？不会吧，看2
2.直接给0.1join吧，地毯。。。。没事。。