iCAx开思网
标题:
从Imageware输出曲线到proe
[打印本页]
作者:
chbagu
时间:
2005-7-6 18:59
标题:
从Imageware输出曲线到proe
怎样从Imageware输出曲线到proe,为何一条曲线输出至proe变成很多段?谁给我指点!
作者:
wosox
时间:
2005-7-9 23:55
请你帖出你提取曲线时的参数设置对话框.用igs输出,应该可以,多段线没关系啊!反正从iw中的曲线只是用来做个位置参考,最后还是要用proe的草绘中的曲线来重建.否则不光顺
欢迎光临 iCAx开思网 (https://www.icax.org/)
Powered by Discuz! X3.3