标题: 请版主，高手帮我解释一段后处理，谢谢！ [打印本页] 作者: CCFF 时间: 2008-12-21 20:10 标题: 请版主，高手帮我解释一段后处理，谢谢！ 版主，高手们，我现在有一段Master cam 的后处理（Wire cut ），能否帮我解读一下，是关于穿线，剪线的，谢谢了。
# --------------------------------------------------------------------------
# NC output, wire thread and cut
# --------------------------------------------------------------------------
pthread1 # Thread wire
wirethd = mi4
if wirethd = one, n, "/ M00 (THREAD WIRE)", e
if wirethd = zero, n, "M20", e
n, "M78",e
n, "M78",e
if water = 1, n, "M80", e
if wire = 1, n, "M82", e
if power = 1, n, "M84", e
wirein = one
pthread # Thread wire
test = zero
if wirein = zero, test = one
if wirethd2 = zero, test = zero
if test = one, pthread1
pbreak2 # Break wire
if power = 1, n, "M85", e
if wire = 1, n, "M83", e
if water = 1, n, "M81", e
n, "/ M00 (CUT WIRE)", e
pbreak1 # Break wire
wirethd = mi4
if wirethd = zero, n, "M21", e
if wirethd = one, pbreak2
wirein = zero
pbreak # Break wire
test = one
if wirein = zero, test = zero
if reposflag = zero, test = zero
test2 = zero
if prv_mi5 = two, test2 = test2 + one
if savsubno = subno, test2 = test2 + one
if subtyp <> zero, test2 = test2 + one
if test2 = 3, test = zero
if prv_mi5 = one, test = zero
test3 = zero
if gcode = 1003, test3 = test3 + one
if wirein = one, test3 = test3 + one
if test3 = two, test = one
if test = one, pbreak1
pthreadcan # Thread wire, cantext
if wirethd2 = one, pthread
pbreakcan # Break wire, cantext
if wirein = one, pbreak1