标题: Plunge with MasterCam [打印本页] 作者: RAY 时间: 2002-4-29 21:33 标题: Plunge with MasterCam Plunging should be the best way to cut this job (160mm high),
I am having problem to make same tool path in MasterCam. Who can help me?作者: RAY 时间: 2002-4-29 21:35
2作者: RAY 时间: 2002-4-30 00:19
GOUGE IN MASTERCAM作者: ajun 时间: 2002-4-30 09:23
将Z轴深度进行限制，提高0.01-0.02就行了。