iCAx开思网

标题: 德馬吉DMU-50/70V/50/70,，MASTERCAM,MＰＧＥＮ５Ｘ．ＰＳＴ如何修改?， [打印本页]

作者: a1b1c1 时间: 2008-3-11 08:15
标题: 德馬吉DMU-50/70V/50/70,，MASTERCAM,MＰＧＥＮ５Ｘ．ＰＳＴ如何修改?，
針對德馬吉DMU-50/70V/50/70 Evolution非正交軸,C轴为TABLE,B轴为YZ轴夹角为45度的雙盤機床，MASTERCAM的五軸通用后处理ＭＰＧＥＮ５Ｘ．ＰＳＴ如何修改?，

作者: a1b1c1 时间: 2008-3-11 08:22
各位大哥: 針對德馬吉DMU-50/70V/50/70 Evolution非正交軸,C轴为TABLE,B轴为YZ轴夹角为45度的雙盤機床，MASTERCAM的五軸通用后处理ＭＰＧＥＮ５Ｘ．ＰＳＴ如何修改?，是不是修改下面的地方即可?還是另外有設置的地方?編程及建模是不是與標準的雙盤一樣?請指教.
# --------------------------------------------------------------------------
# 5 Axis Rotary Settings
# --------------------------------------------------------------------------
#Assign axis address
str_pri_axis "B"
str_sec_axis "C"
str_dum_axis A"
.........

Machine rotary routine settings
mtype    : 3    #Machine type (Define base and rotation plane below)
                  #0 = Table/Table
                  #1 = Tilt Head/Table
                  #2 = Head/Head
                  #3 = Nutator Table/Table
                  #4 = Nutator Tilt Head/Table
                  #5 = Nutator Head/Head
....
#Nutating machine (mtype 3-5) describe the plane that the nutated axis
#lays in,  this is the plane perpendicular to the primary axis and
#secondary axis
nut_ang_pri : -45 #Nutating head secondary axis angle from machine Z positive

作者: s-mastercam 时间: 2020-5-4 09:59
好修改，需要的话联系我 robotpost@163.com

欢迎光临 iCAx开思网 (https://www.icax.org/)