iCAx开思网

标题: PM 可找开UG的文件吗? [打印本页]

作者: HJBMASTERCAM 时间: 2007-12-11 20:07
标题: PM 可找开UG的文件吗?
PM7.0 能找开UG3.0的文件吗??

作者: 00000041 时间: 2007-12-11 20:10
Delcam Exchange In Version 5301

PS-Exchange has been renamed Delcam Exchange.

Added support for Unigraphics NX5 parts.

Added support for IGES Type 402 Form 16 Planar entities.

Delcam Exchange has been upgraded to use the Parasolid version 19.0.172 kernel.

看到上面的消息就知道可以的

[ 本帖最后由 00000041 于 2007-12-11 20:12 编辑 ]

作者: HJBMASTERCAM 时间: 2007-12-11 20:15
Delcam Exchange In Version 5301

PS-Exchange has been renamed Delcam Exchange.

Added support for Unigraphics NX5 parts.

Added support for IGES Type 402 Form 16 Planar entities.

Delcam Exchange has been upgraded to use the Parasolid version 19.0.172 kernel.

看到上面的消息就知道可以的

????小弟不才不知道是什么意思

作者: 00000041 时间: 2007-12-11 20:23
Delcam Exchange In Version 55301
Added support for Unigraphics NX5 parts.

Delcam Exchange 55301版已经增加对UG5 文件的支持

欢迎光临 iCAx开思网 (https://www.icax.org/)