标题: 【求助】收缩率的问题？ [打印本页] 作者: smith 时间: 2003-4-7 09:59 标题: 【求助】收缩率的问题？ 模具设计时有一个收缩率，所以比实际塑件的尺寸要大。
做MOLDFLOW分析时怎么处理收缩率？因为转IGES，STL时是没有考虑收缩率的。作者: laogui2003 时间: 2003-4-7 12:46
you can set the shrink ratio in other cad toll, for example pro/engineer,solidoworks.
but i don't think it is important to set the shrink ratio in moldflow.
if you don't set the shrink ratio,you can also get the accurate result.