iCAx开思网

标题: how to draw it in solidworks [打印本页]

作者: popog    时间: 2006-1-23 20:42
标题: how to draw it in solidworks
THE ORIGINAL CREATER IS: fish0908 (试用期)
Does anyone know how to draw it in solidworks...
Could anyone upload the answer by the rar file ..
thanks..
作者: 不懂和尚    时间: 2006-1-23 22:39
扫描就可以(SWeep)或者放样(Loft)
作者: popog    时间: 2006-1-24 16:17
原帖由 不懂和尚 于 2006-1-23 14:39 发表
扫描就可以(SWeep)或者放样(Loft)

----------------------------------------------------------------
well done ..
but the both ends are importances...
how to draw the two ends ..
thanks.
作者: SW笨笨    时间: 2006-1-24 16:20
要得到根源题目一样结果,应该提供模线
作者: popog    时间: 2006-1-25 00:25
原帖由 SW笨笨 于 2006-1-24 08:20 发表
要得到根源题目一样结果,应该提供模线


并不须要準確的線架構..
只須要大略的外形.尺寸倒是不在乎..
重点是在於兩端,,不知道要如何做..
可能的話請提供檔案来分析步驟..
有那位大俠或solidworks達人..可以幚忙解惑...
不胜感激...




欢迎光临 iCAx开思网 (https://www.icax.org/) Powered by Discuz! X3.3