100 BEGIN PGM 0 MM
102 TOOLCALL1 LZ+50 R Z S3819
104 L X+10.793 Y-67.537 R F MAX M03
106 L Z+50 R F MAX M
108 L Z+10 R F MAX M
110 L Z+0 R F764 M
112 L Y-57.537 R F1528 M
114 CC X0.7926 Y-57.5374
116 C X+.793 Y-47.537 DR+ R F1528 M
118 L X-69.222 R F1528 M
120 CC X-69.2223 Y-42.5374
122 C X-74.222 Y-42.537 DR- R F1528 M
124 L Y+37.782 R F1528 M
126 CC X-69.2223 Y37.7816
128 C X-69.222 Y+42.782 DR- R F1528 M
130 L X+70.808 R F1528 M
132 CC X70.8075 Y37.7816
134 C X+75.808 Y+37.782 DR- R F1528 M
136 L Y-42.537 R F1528 M
138 CC X70.8075 Y-42.5374
140 C X+70.808 Y-47.537 DR- R F1528 M
142 L X+.793 R F1528 M
144 CC X0.7926 Y-57.5374
146 C X-9.207 Y-57.537 DR+ R F1528 M
148 L Y-67.537 R F1528 M
150 L Z+10 R F764 M
152 L Z+50 R F MAX M
154 L R F M2
156 END PGM 0 MM 作者: sinderal 时间: 2005-4-23 20:17
偶記得偶在Surfcam區裡有關SPost(Gpost)的帖子裡面有貼過ㄟ..作者: zengruibiao 时间: 2005-4-24 08:43
版大啊我是要来救急的啊,是米克朗的机的,我找了好多贴都没有关于这个贴子.小的在此谢过了.
